Welcome to 3Leavedcart.com
Collect voucher

0 item

LED T8 tube with integrated PIR sensor

Item NO: 3LST070130

Model NO: LT-PIR-1

Brand: 3Leaved

Favorable Application: Good energy saving solution for corridor, front door, staircase, car park illumination, guaranteed 70% above energy saving, try to believe.

Additional Offer: On door free demo will be provided for project enquiry, price negotiable only for project or wholesale quantity.

Be the first to review this product

Only 5 left

Regular Price: S$38.00

Special Price S$26.80

LED T8 tube with integrated PIR sensor is available for purchase in increments of 1

* Required Fields

Regular Price: S$38.00

Special Price S$26.80

With this product, you earn 54 loyalty point(s).

                                                                                                                     LED tube with Built in PIR sensor


1. T8 LED tube with built in PIR (Passive Infared) sensor provides you an auto run energy saving solution without manual control. Typical illuminating scenarios include corridor, staircase, front door, car park etc.

2. When electricity is applied, the tube will run at dimmer mode which is 30% rated power by default.

3. Once PIR sensor detect human movement in front of tube, it will turn LED tube from dimmer mode to full power and brightness mode remain at full power for one minute before going back to dimmer mode.

Other than PIR control, it is same as normal LED tube. Please look into setup guide section to know how to do substitution for fluorescent tube by D.I.Y.   


Product Specification

 

Rating 9W LED tube with PIR 18W LED tube with PIR
dimension       T8 600 mm       T8 1200 mm
detection range       6-8 meter       6-8 meter
detection angles      120 degree       120 degree
luminous flux         800lm        1700lm
dimmer mode         200lm        400lm
Voltage      220-240ACV      220-240ACV
CRI          >75          >75


                                                       Guide for changing fluorescent tube to LED tube

 

LED T8 tube has standard connection G13 base which is same as T8 fluorescent tube, you will have no problem to replace fluorescent T8 tube with LED T8 tube in mechanical respect.

However, LED tube need not ballast and starter, especially LED tube can not work with electronics ballast, therefore, some wiring work is needed.

 1. if your current fluorescent tube is using magnetic ballast with a starter, you will need to take off the starter and short circuit the ballast as illustrated as below figure.

How to change fluorescent tube with magnetic ballast to LED tube


2. If your current fluorescent tube is using electronics ballast, you will need to take off the ballast, re-wiring power supply L (live wire) to one end of LED tube (any one pin or both pins), N (neutral wire) to another end of LED tube (any one pin or both pins). See below illustration.

How to change fluorescent tube with electronic ballast to LED tube

Write Your Own Review

Only registered users can write reviews. Please, log in or register